Usefp (Slash Command): Difference between revisions
Jump to navigation
Jump to search
BlackSpectre (talk | contribs) No edit summary |
BlackSpectre (talk | contribs) No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
__NOTOC__ | |||
== Slash Command == | == Slash Command == | ||
{{SlashCommandArticle|command=usefp|options=[0-1]|note=Use a floating point render target for HDR lighting effects if available.}} | {{SlashCommandArticle|command=usefp|options=[0-1]|note=Use a floating point render target for HDR lighting effects if available.}} | ||
| Line 23: | Line 24: | ||
{{Navbox Graphic Commands}} | {{Navbox Graphic Commands}} | ||
[[Category:Graphic Commands]] | [[Category:Graphic Commands]] | ||
[[Category:Command Line Parameters]] | [[Category:Command Line Parameters]] | ||
Latest revision as of 22:22, 19 February 2024
Slash Command
/usefp [0-1]
Use a floating point render target for HDR lighting effects if available.
- 0 = Disable floating point, 1 = Enable floating point. Default = 0.
- This command enables a dynamic range of values for HDR lighting effects rather than a hard, constant value such as 5. Floating-point values allow you to represent very large differences in light intensity in your scene, without knowing beforehand what the maximum and minimum light values will be.
- HDR must be enabled first using /usehdr before the /usefp command will work.
Command Line Parameter
The command can be run at log-in as a Command Line Parameter. For example, -usefp 1.
Example
/usefp 1
Also